Brocade Fabric OS Encryption Administrator’s Guide Support Manual de usuario descargar pdf (Pagina 301)

Fabric OS Encryption Administrator’s Guide (SKM/ESKM) 281

53-1002923-01

Brocade Encryption Switch removal and replacement

21. Import the signed CSR/Cert onto the new node.

22. Register back the signed KAC CSR/Cert onto the new node using the following command.

Admin:switch> cryptocfg --reg –KACcert

23. Register the username and password on the new node with the same username and password

as those used by the other nodes in the EG (created on the HP SKM/ESKM appliance) using

the following command.

Admin:switch> cryptocfg --reg –KACLogin

24. Check the EE state using the following command to ensure that the EE is online.

Admin:switch> cryptocfg -–show –localEE

25. From the new Brocade Encryption Switch, invoke the following command to set the default

zone as allAccess so the configuration from the existing Fabric is pushed to the new Brocade

Encryption Switch.

Admin:switch> defzone –allaccess

26. Invoke the following command on the new Brocade Encryption Switch.

Admin:switch> cfgsave

27. Replace the FC Cables to the new Brocade Encryption Switch.

28. Invoke the cfgsave command on any switch in that fabric. The fabric configuration from the

existing fabric will be merged into the new Brocade Encryption Switch.

29. Verify that defzone is set as no access.

30. If HA cluster membership for the old Brocade Encryption Switch was in place, move container

movement to the new Brocade Encryption Switch using the following procedure.

a. Replace the old EE with the new EE using the following command on the group leader.

Admin:switch> cryptocfg –replace <WWN of Old BES> <WWN of new BES>

b. Issue commit.

Admin:switch> cryptocfg --commit

c. Replace the HA cluster membership from the old EE to the new EE using the following

command on the group leader.

Admin:switch> cryptocfg –replace –haclustermember <HA cluster name> <WWN

of old Brocade Encryption Switch> <WWN of new Brocade Encryption Switch>

d. Issue commit.

Admin:switch> cryptocfg --commit

e. If “manual” failback was set on the HA cluster, user intervention will be required to

manually fail back the LUNs owned by the newly replaced Brocade Encryption Switch.

1 2 ... 296 297 298 299 300 301 302 303 304 305 306 ... 323 324

Sin comentarios

Brocade Fabric OS Encryption Administrator’s Guide Support Manual de usuario Pagina 301