Brocade Fabric OS Encryption Administrator’s Guide Support Manual de usuario descargar pdf (Pagina 102)

84 Fabric OS Encryption Administrator’s Guide (KMIP)

53-1002747-02

Adding target disk LUNs for encryption

FIGURE 75 Select Initiator Port dialog box

The dialog box is used to select an initiator port when configuring multiple I/O paths to a disk

LUN. The dialog box contains the following information:

• Storage Array: Displays the storage array that was selected from the LUN view prior to

launching the wizard.

• Host: The host selected from the LUN view prior to launching the wizard.

• Initiator Port table: Lists initiator ports using the following identifiers:

• Initiator Port

• Initiator Port Name

• Initiator Node Name

• Fabric

5. Select the initiator port from the Initiator Port table, then click Next.

LUN discovery is launched and a progress bar displays. There are four possible outcomes:

- A message displays indicating no LUNs were discovered. Click OK to dismiss the message

and exit the wizard.

- A message displays indicating LUNs have been discovered, but are already configured.

Click OK to dismiss the message and exit the wizard.

- A message displays indicating that the target is not in the right state for discovering LUNs.

Click OK to dismiss the message and exit the wizard.

- The Select LUN dialog box displays (Figure 76), which lists discovered LUNs that are

available.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 321 322

Sin comentarios

Brocade Fabric OS Encryption Administrator’s Guide Support Manual de usuario Pagina 102