Brocade FastIron Ethernet Switch Software Licensing Guide Manual de usuario descargar pdf (Pagina 33)

Licensing for Ports on Demand

● Overview of licensing for Ports on Demand.................................................................... 31

● Configuring PoD on an interface..................................................................................... 32

● Configuring the upper PoD ports in a stack for ICX 6610 devices only.......................... 32

● Displaying license configuration for PoD ports after a license upgrade.......................... 33

● Upgrading or downgrading configuration considerations for PoD...................................36

● Ports on Demand licensing on the ICX 6650.................................................................. 40

The following table lists the individual BrocadeFastIron switches and the software licensing features

they support.

Supported software PoD licensing featuresTABLE 5

Feature FSX 800 FSX

1600

FCX ICX 6610 ICX 6450

ICX 6650 ICX 7750

PoD licensing No No Yes Yes Yes

License

generation

No No Yes Yes Yes

License query No No Yes Yes Yes

Deleting a

license

No No Yes Yes Yes

Overview of licensing for Ports on Demand

NOTE

Licensing for Ports on Demand is applicable to ICX 6610 , ICX 6450, and ICX 6650 devices.

You can use the Ports on Demand (PoD) feature to enable 1 Gbps ports to 40 Gbps port speed.

By default, regardless of what SFP+ media optic is used, the ICX 6610 device has eight active 1 Gbps

uplink ports. To increase the uplink capacity of four ports from 1 Gbps to 10 Gbps port speed, purchase

a single ICX6610-10G-LIC-POD license. To increase the uplink capacity of all eight ports from 1 Gbps

to 10 Gbps port speed, purchase a second ICX6610-10G-LIC-POD license.

NOTE

For 10Gbps PoD licenses, the ICX 6610 device does not support a trial license along with a permanent

license at the same time even for different ports. The permanent license causes the trial license to be

marked as obsolete.

The ICX 6450 device has four active uplink and stacking ports on slot 2. By default, regardless of what

SFP+ media optic is used, ports 1 and 3 are 10 Gbps ports. By default, without a license at bootup,

ports 2 and 4 come up in 10 Gbps port speed in an error disabled state. To enable ports 2 and 4 to 10

Gbps port speed, purchase the ICX6450-2X10G-LIC-POD license. For more information about enabling

FastIron Ethernet Switch Software Licensing Guide

53-1003091-02

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 57 58

Sin comentarios

Brocade FastIron Ethernet Switch Software Licensing Guide Manual de usuario Pagina 33