Brocade Multi-Service IronWare Multiprotocol Label Switch Manual de usuario descargar pdf (Pagina 114)

100

101

90 Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide

53-1003031-02

Configuring MPLS

This section explains how to set up MPLS on devices. It contains the following topics:

• “Enabling MPLS”

• “RSVP message authentication”

• “Configuring MPLS on a VE interface”

• “Setting up signaled LSPs”

• “Configuring signaled LSP parameters”

• “Configuring an adaptive LSP”

• “Configuring MPLS Fast Reroute using one-to-one backup”

• “Protecting MPLS LSPs through a bypass LSP”

Enabling MPLS

MPLS is disabled by default. To enable MPLS on a device, the user must perform the steps listed

below.

1. Enable MPLS on the device

2. Enable MPLS on individual interfaces

3. Set global MPLS policy parameters (optional)

4. Set traffic engineering parameters for MPLS-enabled interfaces (optional)

5. Set RSVP parameters (optional)

Enabling MPLS on the device

To enable MPLS on the device, enter the following commands.

Brocade> enable

Brocade# configure terminal

Brocade(config)# router mpls

Syntax: [no] router mpls

To disable MPLS on the device, use the [no] form of the command.

Enabling MPLS on individual interfaces

NOTE

To quickly enable RSVP on multiple interfaces, a range of MPLS interfaces can be specified.

However, the user must configure other parameters, such as the amount of reservable bandwidth

on each interface individually.

After the user enables MPLS globally on the device, the user can enable it on one or more

interfaces. For example, to enable MPLS on interface e 3/1.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 851 852

Comentarios a estos manuales

Sin comentarios

Brocade Multi-Service IronWare Multiprotocol Label Switch Manual de usuario Pagina 114

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Multi-Service IronWare Multiprotocol Label Switch