Brocade Fabric OS Encryption Administrator’s Guide Support Manual de usuario Pagina 106

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 300
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 105
88 Fabric OS Encryption Administrator’s Guide (LKM/SSKM)
53-1002925-01
Rekeying all disk LUNs manually
2
FIGURE 67 Selecting the Re-Key All operation
A warning displays, requesting confirmation to proceed with the rekey operation.
3. Click Yes.
Rekeying operations begin on up to 10 LUNs. If more than 10 LUNs are configured on the
switch, the remaining rekey operations are held in the pending state.
4. Open the Encryption Target Disk LUNs dialog box to see LUNs being rekeyed and LUNs
pending.
a. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box. (Refer to Figure 6 on page 14.)
b. Select the encryption switch from the Encryption Center Devices table, then select Targets
from the menu task bar.
The Encryption Targets dialog box displays. (Refer to Figure 45.)
5. Select a disk LUN device from the table, then click LUNs.
The Encryption Targets Disk LUNs dialog box displays. (Refer to Figure 68.) The dialog box lists
the status of the rekey operation.
.
FIGURE 68 Pending manual rekey operations
Vista de pagina 105
1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 299 300

Comentarios a estos manuales

Sin comentarios