Brocade Fabric OS Encryption Administrator’s Guide Support Manual de usuario descargar pdf (Pagina 111)

Fabric OS Encryption Administrator’s Guide (LKM/SSKM) 93

53-1002925-01

Viewing time left for auto rekey

You can view the time remaining until auto rekey is no longer active for a disk LUN. The information

is expressed as the difference between the next rekey date and the current date and time, and is

measured in days, hours, and minutes.

Although you cannot make changes directly to the table, you can modify the time left using CLI. For

more information, refer to Chapter 3, “Configuring Encryption Using the CLI”.

To view the time left for auto rekey, follow these steps:

1. Select Configure > Encryption from the menu task bar to display the Encryption Center

dialog box. (Refer to Figure 6 on page 14.)

2. Select a group, switch, or engine from the Encryption Center Devices table for which to view the

auto rekey information, then select Group/Switch/Engine > Targets from the menu task bar.

NOTE

You can also select a group, switch, or engine from the Encryption Center Devices table, then

click the Targets icon.

The Encryption Targets dialog box displays. (Refer to Figure 45 on page 62.)

3. Select a target disk device from the table, then click LUNs.

The Encryption Target Disk LUNs dialog box displays. The time left for auto rekey information is

listed in the table. (Refer to Figure 71).

FIGURE 71 Time left for auto rekey

Viewing and editing switch encryption properties

To view switch encryption properties, complete the following steps:

1. Select Configure > Encryption from the menu task bar to display the Encryption Center

dialog box. (Refer to Figure 6 on page 14.)

2. Select a switch or encryption engine from the Encryption Center Devices table, then select

Switch/Engine > Properties from the menu task bar, or right-click a switch or encryption engine

and select Properties.

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 299 300

Sin comentarios

Brocade Fabric OS Encryption Administrator’s Guide Support Manual de usuario Pagina 111