Brocade FastIron Ethernet Switch Platform and Layer 2 Swit Manual de usuario descargar pdf (Pagina 260)

100

101

CLI display of STP information (Continued)TABLE 46

Field Description

Priority Hex This device or VLAN STP priority. The value is shown in hexadecimal format.

NOTE

If you configure this value, specify it in decimal format. Refer to Changing STP bridge

parameters on page 256.

Max age sec The number of seconds this device or VLAN waits for a configuration BPDU from the root

bridge before deciding the root has become unavailable and performing a reconvergence.

Hello sec The interval between each configuration BPDU sent by the root bridge.

Hold sec The minimum number of seconds that must elapse between transmissions of consecutive

Configuration BPDUs on a port.

Fwd dly sec The number of seconds this device or VLAN waits following a topology change and

consequent reconvergence.

Last Chang sec The number of seconds since the last time a topology change occurred.

Chg cnt The number of times the topology has changed since this device was reloaded.

Bridge Address The STP address of this device or VLAN.

NOTE

If this address is the same as the Root ID, then this device or VLAN is the root bridge for its

spanning tree.

Port STP parameters

Port Num The port number.

Priority Hex The port STP priority, in hexadecimal format.

NOTE

If you configure this value, specify it in decimal format. Refer to Changing STP port parameters

on page 257.

Path Cost The port STP path cost.

Spanning Tree Protocol

260 FastIron Ethernet Switch Platform and Layer 2 Switching Configuration Guide

53-1003086-04

1 2 ... 255 256 257 258 259 260 261 262 263 264 265 ... 453 454

Comentarios a estos manuales

Sin comentarios

Brocade FastIron Ethernet Switch Platform and Layer 2 Swit Manual de usuario Pagina 260

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade FastIron Ethernet Switch Platform and Layer 2 Swit