Brocade MLX Series and NetIron Family (Supporting Multi-Se Manual de usuario descargar pdf (Pagina 49)

Brocade MLX Series and NetIron Family Documentation Updates 41

53-1003301-07

FE access recovery disable

To disable a RAS feature that will power-cycle a switch fabric module if SW cannot access fabric

element.

Syntax: system-init fe-access-recovery-disable

Usage Guidelines

The system does the periodic monitoring of FE access and keeps a log for this by code monitoring

fabric links and kicks off when number of links down exceeds defined threshold for traffic. However

if failure detection configuration is enabled, you need to use these commands for recovery.

Output

The ~ system-init ~ command configures the following information:

Examples:

Brocade(config)#system-init fe-access-recovery-disable

Brocade(config)#no system-init fe-access-recovery-disable

Brocade(config)#

TABLE 7

Command Description

block-g1-sfm Configure the system to block g1 switch fabric module.

fabric-data-mode Configure the fabric data mode.

fabric-failure-detection

Configure the system to automatically detect and shutdown failure

fabric

fe-access-recovery-disable Configure fabric element access failure recovery disable.

max-tm-queues Configure maximum number queues in traffic manager to 4.

mlxe32-24x10g-enable Configure the system to accept 24x10G module.

tm-credit-size Configure traffic manager credit size.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 61 62

Sin comentarios

Brocade MLX Series and NetIron Family (Supporting Multi-Se Manual de usuario Pagina 49