Brocade MLX Series and NetIron Family (Supporting Multi-Se Manual de usuario descargar pdf (Pagina 50)

42 Brocade MLX Series and NetIron Family Documentation Updates

53-1003301-07

Setting the delay before bringing up the CCEP port

Use the client-interfaces delay command to set the delay before bringing up the CCEP port. This

command is used to set the delay, so that after a node is reloaded, with just L2vpn peer alone, the

delay to bring up the CCEP port will be the designated value.

Brocade(config-cluster-TOR)#client-interfaces delay 60

Syntax: no] client-interfaces delay time in sec

The default value for delay is 90 seconds. The acceptable values range between 20 to 1800

seconds.

Setting the OpenFlow system maximum

The system-max openflow-pvlan-entries command sets the CAM size of OpenFlow protected VLAN

entries for the device. By default, this value is set to 0.

Brocade (config)# system-max openflow-pvlan-entries 2000

Syntax: system-max openflow-pvlan-entries value

The value variable represents the number of port and protected VLAN combination entries that can

be configured in the system. The range is from 0 to 2048. after using this command, you must

reload the system.

The system-max openflow-unprotectedvlan-entries command sets the CAM size of OpenFlow

unprotected VLAN entries for the device. By default, this value is set to 0.

Brocade(config)# system-max openflow-unprotectedvlan-entries 1000

Syntax: system-max openflow-unprotectedvlan-entries value

The value variable represents the number of port and unprotected VLAN combination entries that

can be configured in the system. The range is from 0 to 4096. after using this command, you must

reload the system.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 61 62

Sin comentarios

Brocade MLX Series and NetIron Family (Supporting Multi-Se Manual de usuario Pagina 50