Brocade Fabric OS Encryption Administrator’s Guide Support Manual de usuario descargar pdf (Pagina 116)

96 Fabric OS Encryption Administrator’s Guide (DPM)

53-1002922-01

Using the Encryption Targets dialog box

The Encryption Targets dialog box enables you to send outbound data that you want to store as

ciphertext to an encryption device. The encryption target acts as a virtual target when receiving

data from a host, and as a virtual initiator when writing the encrypted data to storage.

NOTE

The Encryption Targets dialog box enables you to launch a variety of wizards and other related

dialog boxes.

To access the Encryption Targets dialog box, complete the following steps.

1. Select Configure > Encryption from the menu task bar to display the Encryption Center

dialog box. (Refer to Figure 6 on page 14.)

2. Select a group, switch, or engine from the Encryption Center Devices table, then select

Group/Switch/Engine > Targets from the menu task bar.

NOTE

You can also select a group, switch, or engine from the Encryption Center Devices table, then

click the Targets icon.

The Encryption Targets dialog box displays. (Refer to Figure 72.) The targets currently being

encrypted by the selected group, switch, or encryption engine are listed. If a group is selected,

all configured targets in the group are displayed. If a switch is selected, all configured targets

for the switch are displayed.

FIGURE 72 Encryption Targets dialog box

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 331 332

Sin comentarios

Brocade Fabric OS Encryption Administrator’s Guide Support Manual de usuario Pagina 116