Brocade Fabric OS Encryption Administrator’s Guide Support Manual de usuario descargar pdf (Pagina 142)

122 Fabric OS Encryption Administrator’s Guide (DPM)

53-1002922-01

Viewing and editing encryption group properties

All encryption engines in the encryption group share the tape pool definitions. Tapes can be

encrypted by any encryption engine in the group where the container for the tape target LUN is

hosted. The tape media is mounted on the tape target LUN.

Tape pool definitions are not needed to read a tape. The tape contains enough information

(encryption method and key ID) to read the tape. Tape pool definitions are only used when writing

to tape. Tape pool names and numbers must be unique within the encryption group.

Adding tape pools

A tape pool can be identified by either a name or a number, but not both. Tape pool names and

numbers must be unique within the encryption group. When a new encryption group is created, any

existing tape pools in the switch are removed and must be added.

1. Select Configure > Encryption from the menu task bar to display the Encryption Center

dialog box. (Refer to Figure 6 on page 14.)

2. Select a group from the Encryption Center Devices table, then select Group > Tape Pools from

the menu task bar.

NOTE

If groups are not visible in the Encryption Center Devices table, select View > Groups from the

menu task bar.

3. Click Add.

The Add Tape Pool dialog box displays. (Refer to Figure 88.) The Name tape pool label type is

the default; however, you can change the tape pool label type to Number. (Refer to Figure 89.)

FIGURE 88 Add Tape Pool by name dialog box

FIGURE 89 Add Tape Pool by number dialog box

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 331 332

Sin comentarios

Brocade Fabric OS Encryption Administrator’s Guide Support Manual de usuario Pagina 142