Brocade Multi-Service IronWare Security Configuration Guid Manual de usuario descargar pdf (Pagina 334)

316 Multi-Service IronWare Security Configuration Guide

53-1003035-02

Displaying 802.1x information

The following table describes the information displayed by the show dot1x command.

TABLE 49 Output from the show dot1x command

This field... Displays...

PAE Capability The Port Access Entity (PAE) role for the device. This is always “Authenticator

Only”.

system-auth-control Whether system authentication control is enabled on the device. The

dot1x-enable command enables system authentication control on the device.

Number of ports enabled Number of interfaces on the devices that have been enabled for 802.1x.

re-authentication Whether periodic re-authentication is enabled on the device. Refer to

“Configuring periodic re-authentication”.

When periodic re-authentication is enabled, the device automatically

re-authenticates clients every 3,600 seconds by default.

global-filter-strict-security Whether or not strict security mode is enabled globally.

quiet-period When the device is unable to authenticate a client, the amount of time the

device waits before trying again (default 60 seconds).

Refer to “Setting the quiet period” for information on how to change this

setting.

tx-period When a client does not send back an EAP-response or identity frame, the

amount of time the device waits before retransmitting the EAP-request or

identity frame to a client (default 30 seconds).

Refer to “Setting the interval for retransmission of EAP-request or identity

frames” for information on how to change this setting.

supp-timeout When a client does not respond to an EAP-request frame, the amount of time

before the device retransmits the frame.

Refer to “Specifying a timeout for retransmission of EAP-request frames to the

client” for information on how to change this setting.

server-timeout When the Authentication Server does not respond to a message sent from the

client, the amount of time before the device retransmits the message.

Refer to “Specifying a timeout for retransmission of messages to the

Authentication Server” for information on how to change this setting.

max-req The number of times the device retransmits an EAP-request or identity frame if

it does not receive an EAP-response or identity frame from a client (default 2

times).

Refer to “Specifying the number of EAP-request or identity frame

retransmissions” for information on how to change this setting.

re-authperiod How often the device automatically re-authenticates clients when periodic

re-authentication is enabled (default 3,600 seconds).

Refer to “Configuring periodic re-authentication” for information on how to

change this setting.

security-hold-time This field is not supported.

Protocol Version The version of the 802.1x protocol in use on the device.

Auth-fail-action The configured authentication-failure action. This can be Restricted VLAN or

Block Traffic.

Mac Session Aging Whether aging for dot1x-mac-sessions has been enabled or disabled for

permitted or denied dot1x-mac-sessions.

1 2 ... 329 330 331 332 333 334 335 336 337 338 339 ... 369 370

Comentarios a estos manuales

Sin comentarios

Brocade Multi-Service IronWare Security Configuration Guid Manual de usuario Pagina 334

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Multi-Service IronWare Security Configuration Guid