Brocade Multi-Service IronWare Multicast Configuration Gui Manual de usuario descargar pdf (Pagina 78)

66 Multi-Service IronWare Multicast Configuration Guide

53-1003032-02

Multicast Outgoing Interface (OIF) list optimization

Syntax: show ip pim mcache fid fid-id

The fid-id variable allows you to display an entry that matches a specified fid.

RP Show the IP address of the RP.

num_oifs Show the count of the outgoing interfaces.

inherited_oifs Show the PIM Sparse mode inherited outgoing interfaces.

blocked_oifs Show the PIM Sparse mode blocked outgoing interfaces.

Flags Show the flags associated with the forward entry.

fast ports ethe Shows the forwarding port ID.

L3 Show whether the traffic is switched or routed out of the interface.

(HW) Show whether the entry is software forwarded or hardware forwarded.

sm Sets the flag to 1, if the Sparse Mode entry is enabled and 0, if the PIM dense mode

entry is enabled.

ssm Sets the flag to 1, if the SSM mode entry is enabled, or else sets the flag to 0.

hw Sets the flag to 1, if the candidate for hardware forwarding is enabled, or else sets the

flag to 0.

fast Sets the flag to 1, if the resources are allocated for hardware forwarding, or else sets

the flag to 0.

slow Sets the flag to 1, if the entry is not a candidate for hardware forwarding or the

resource allocation is failed, or else sets the flag to 0.

leaf Sets the flag to 1, if DVMRP is enabled, or else sets the flag to 0.

prun Sets the flag to 1, if PIM is enabled, or else sets the flag to 0.

tag Sets the flag to 1, if there is a need for allocating entries from the replication table, or

else sets the flag to 0.

needRte Sets the flag to 1, if there is no route to the source and RP is available, or else sets the

flag to 0.

msdp_adv Sets the flag to 1, if RP is responsible for the source and must be advertised to its

peers.

AgeSltMsk Shows the slot number on which MP expects ingress traffic.

FID Shows the FID resource allocated for a particular entry.

MVID Shows the MVID resource allocated for a particular entry.

RegPkt Shows the number of PIM register packet received.

AvgRate Shows the average data traffic rate for the mcache entry.

profile Shows the profile ID associated with the stream.

Number of matching

entries

Shows the number of mcache entry.

TABLE 18 Output parameters of the show ip pim mcache fid 8 command (Continued)

Field Description

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 215 216

Sin comentarios

Brocade Multi-Service IronWare Multicast Configuration Gui Manual de usuario Pagina 78