Brocade Network OS NETCONF Operations Guide v4.1.1 Manual de usuario descargar pdf (Pagina 170)

100

101

138 Network OS NETCONF Operations Guide

53-1003231-02

Configuring a Fibre Channel port for long distance operation

b. In the <fc-speed-cfg> element, specify “auto”, “1gbps”, “2gbps”, “4gbps”, or “8gbps” to

set the port speed.

The following example sets the port speed to 4 Gbps for port 1 on routing bridge 8.

<?xml version="1.0" encoding="UTF-8"?>

<edit-config>

</target>

<fc-port>

<fc-port-speed>4gbps</fc-port-speed>

</fc-port>

</interface>

</config>

</edit-config>

</rpc>

<rpc-reply message-id="1303" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">

<ok/>

</rpc-reply>

Configuring a Fibre Channel port for long distance operation

You can use the NETCONF interface to establish the long distance mode and to allocate full-size

frame buffers on a specific port. Network OS supports the Normal Mode (LO), Extended Mode (LE),

Dynamic Long-Distance Mode (LD), and Static Long-Distance Mode (LS) long distance link modes.

For details about these long distance link modes, refer to the Network OS Administrator’s Guide.

Before configuring an extended ISL, ensure that the following conditions are met:

• The ports on both ends of the ISL are operating at the same port speed, and can be configured

at the same distance level without compromising local switch performance.

• Only qualified Brocade SFPs are used. Only Brocade-branded or certain Brocade-qualified

SFPs are supported.

To configure a Fibre Channel port for long distance operation, perform the following steps.

1. Issue the <edit-config> RPC to configure the <interface> node in the

urn:brocade.comn:mgmt:brocade-interface namespace.

2. Under the <interface> node, include the <fc-port> node element.

3. Under the <fc-port> node element, include the following leaf elements.

a. In the <name> element, identify the port you want to configure. Identify the port by routing

bridge-ID/slot/port.

b. for 8 Gbps only, in the <fill-word> element, set the fill word to the same value as for the

remote port.

Possible values include “idle-idle”, “arbff-arbff”, “idle-arbff”, aa-then-ia”. The default value

is “idle-idle”.

c. In the <long-distance> element, set the long distance mode.

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 621 622

Comentarios a estos manuales

Sin comentarios

Brocade Network OS NETCONF Operations Guide v4.1.1 Manual de usuario Pagina 170

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Network OS NETCONF Operations Guide v4.1.1