Brocade Network OS NETCONF Operations Guide v4.1.1 Manual de usuario descargar pdf (Pagina 517)

100

101

Network OS NETCONF Operations Guide 485

53-1003231-02

Chapter

Configuring sFlow

In this chapter

•sFlow configuration with NETCONF overview. . . . . . . . . . . . . . . . . . . . . . . . 485

•Configuring the sFlow protocol globally . . . . . . . . . . . . . . . . . . . . . . . . . . . . 485

•Interface-specific administrative tasks for sFlow . . . . . . . . . . . . . . . . . . . . 487

•Flow-based sFlow. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 489

sFlow configuration with NETCONF overview

This chapter provides procedures for configuring sFlow using the NETCONF interface. Refer to the

Network OS Administrator’s Guide for related conceptual and overview information about the sFlow

protocol.

Through the NETCONF interface, you can perform the following operations that affect the

functioning of sFlow:

• Use the <edit-config> RPC to activate, configure, or deactivate the sFlow protocol globally.

• Use the <edit-config> RPC to activate, configure, or deactivate sFlow on specific 10-Gigabit,

40-Gigabit, or Gigabit Ethernet interfaces.

• Use the <get-config> RPC to verify all or part of the global or per-port sFlow configuration.

sFlow must be enabled globally before it can be enabled on a specific interface.

sFlow parameters are defined in the brocade-sflow YANG module. For information about the

brocade-sflow YANG module, refer to the Network OS YANG Reference Manual.

Configuring the sFlow protocol globally

Brocade recommends that you configure sFlow globally on the Brocade switch first, and then

enable sFlow on specific interface ports and make custom alterations, because sFlow parameters

at the interface level can differ from those at the global level. For details, refer to “Interface-specific

administrative tasks for sFlow” on page 487.

Enabling sFlow globally does not enable it on interface ports. sFlow must be explicitly enabled on

all the required interface ports. Refer to “Enabling and customizing sFlow on specific interfaces” on

page 487.

NOTE

On the Brocade VDX 8770, Switched Port Analyzer (SPAN), and sFlow can be enabled at the same

time. However, on the Brocade VDX 6720, SPAN and sFlow cannot be enabled at the same time.

1 2 ... 512 513 514 515 516 517 518 519 520 521 522 ... 621 622

Comentarios a estos manuales

Sin comentarios

Brocade Network OS NETCONF Operations Guide v4.1.1 Manual de usuario Pagina 517

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Network OS NETCONF Operations Guide v4.1.1