Brocade Network OS NETCONF Operations Guide v4.1.1 Manual de usuario descargar pdf (Pagina 561)

100

101

Network OS NETCONF Operations Guide 529

53-1003231-02

Performing basic OSPF configuration

<range>

<range-address>193.45.0.0</range-address>

<range-mask>255.255.0.0</range-mask>

<range-effect>not-advertise</range-effect>

</range>

</area>

</ospf>

</router>

</rbridge-id>

</config>

</edit-config>

</rpc>

<rpc-reply message-id="2608" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">

<ok/>

</rpc-reply>

Assigning interfaces to an area

Once you define OSPF areas, you can assign interfaces to the areas. All router ports must be

assigned to one of the defined areas on an OSPF router. When a port is assigned to an area, all

corresponding subnets on that port are automatically included in the assignment.

For example, to assign interface 7/1/8 of a router area whose area ID is 192.5.0.0, and then save

the changes, issue the following RPC.

<edit-config>

</target>

<ip>

<interface-te-ospf-conf

xmlns="urn:brocade.com:mgmt:brocade-ospf">

<ospf1>

</ospf1>

</interface-te-ospf-conf>

</ip>

</tengigabitethernet>

</interface>

</config>

</edit-config>

</rpc>

<rpc-reply message-id="2609" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">

<ok/>

</rpc-reply>

If you want to set an interface to passive mode, use the empty <passive/> leaf element instead of

the <area> leaf element in the previous example.

If you want to block flooding of outbound LSAs on specific OSPF interfaces, instead of the <area>

element in the previous example, using the following elements:

1 2 ... 556 557 558 559 560 561 562 563 564 565 566 ... 621 622

Comentarios a estos manuales

Sin comentarios

Brocade Network OS NETCONF Operations Guide v4.1.1 Manual de usuario Pagina 561

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Network OS NETCONF Operations Guide v4.1.1