
The following figure illustrates hitless stacking support in a stack split.
FIGURE 15 Hitless stacking support in a stack split
Hitless stacking default behavior
Hitless stacking is disabled by default. When disabled, the following limitations are in effect:
• If a failover occurs, every unit in the stack will reload
• Manual switchover is not allowed. If the CLI command stack switch-over is entered, the following
message will appear on the console:
Switch-over is not allowed. Reason: hitless-failover not configured.
Hitless stacking default behavior
FastIron Ethernet Switch Stacking Configuration Guide 107
53-1003090-02
Comentarios a estos manuales