Brocade Multi-Service IronWare Routing Configuration Guide Manual de usuario descargar pdf (Pagina 225)

100

101

Multi-Service IronWare Routing Configuration Guide 197

53-1003033-02

Adding additional parameters

Example

Brocade(config-ospf-router)#default-information-originate route-map defaultToOspf

Brocade(config-ospf-router)#default-information-originate always

Brocade(config-ospf-router)#default-information-originate metric 200

In the above example, default-information-originate’ is enabled with the route-map parameter for

the first CLI and then the always and metric is appended to the existing configuration. The running

configuration of the above three split commands would be as follows:

Brocade(config-ospf-router)#default-information-originate always metric 200

route-map defaultToOspf

Disabling configuration

To disable the route-map parameter from the configuration, enter the following command:

Brocade(config-ospf-router)# no default-information-originate route-map

defaultToOspf

The above CLI would retain the configuration with default-information-originate alone and

route-map option would get reset or removed.

The following commands with any or all of the options will remove the options from the

default-information-originate command if any of the options are configured:

Brocade(config-ospf-router)#no default-information-originate always

Brocade(config-ospf-router)#no default-information-originate always route-map

test

Brocade(config-ospf-router)#no default-information-originate always route-map

test metric 200

Brocade(config-ospf-router)#no default-information-originate always route-map

test metric 200 metric-type type1

In the following example, the parameters of the default-information-originate command are reset if

they are configured and if none of the parameters are configured then, these commands will have

no effect.

To disable the origination of default route, issue the command with “no” option and without any

other options. This would remove the configuration of the default information origination even if

any of the above mentioned options are configured.

Syntax: [no] default-information-originate [always] [metric metric value] [metric-type metric-type]

[route-map rmap-name]

The always parameter advertises the default route regardless of whether the router has a default

route. This option is disabled by default.

The metric value parameter specifies a metric for the default route. If this option is not used, the

default metric is used for the route.

The metric-type type parameter specifies the external link type associated with the default route

advertised into the OSPF routing domain. The type can be one of the following:

• type1 – Type 1 external route

• type2 – Type 2 external route

If you do not use this option, the default redistribution metric type is used for the route type.

1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 845 846

Comentarios a estos manuales

Sin comentarios

Brocade Multi-Service IronWare Routing Configuration Guide Manual de usuario Pagina 225

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Multi-Service IronWare Routing Configuration Guide