Brocade Multi-Service IronWare Routing Configuration Guide Manual de usuario descargar pdf (Pagina 584)

100

101

556 Multi-Service IronWare Routing Configuration Guide

53-1003033-02

Displaying BGP4+ information

Syntax: show ipv6 /jointfilesconvert/1441120/bgp neighbor ipv6-address attribute-entries

The ipv6-address parameter displays the route attribute entries for a specified neighbor. You must

specify this address in hexadecimal using 16-bit values between colons as documented in RFC

2373.

This display shows the following information.

TABLE 111 BGP4+ neighbor route-attribute entries information

This field... Displays...

Total number of BGP Attribute

Entries

The number of route attribute entries for the specified neighbor.

Next Hop The IPv6 address of the next hop router for routes that have this set of

attributes.

Metric The cost of the routes that have this set of attributes.

Origin The source of the route information. The origin can be one of the following:

• EGP – The routes with this set of attributes came to BGP4+ through EGP.

• IGP – The routes with this set of attributes came to BGP4+ through IGP.

• INCOMPLETE – The routes came from an origin other than one of the

above. For example, they may have been redistributed from OSPFv3 or

RIPng.

When BGP4+ compares multiple routes to a destination to select the best

route, IGP is preferred over EGP and both are preferred over INCOMPLETE.

Originator The originator of the route in a route reflector environment.

Cluster List The route-reflector clusters through which this set of attributes has passed.

Aggregator Aggregator information:

• AS Number shows the AS in which the network information in the

attribute set was aggregated. This value applies only to aggregated routes

and is otherwise 0.

• Router-ID shows the that originated this aggregator.

Atomic Whether the network information in this set of attributes has been aggregated

and this aggregation has resulted in information loss:

• TRUE – Indicates information loss has occurred

• FALSE – Indicates no information loss has occurred

• None – Indicates the attribute is not present.

Note: Information loss under these circumstances is a normal part of BGP4+

and does not indicate an error.

Local Pref The degree of preference for routes that use this set of attributes relative to

other routes in the local AS.

Communities The communities that routes with this set of attributes are in.

AS Path The ASs through which routes with this set of attributes have passed. The local

AS is shown in parentheses.

Address For debugging purposes only.

Hash For debugging purposes only.

Reference Counts For debugging purposes only.

1 2 ... 579 580 581 582 583 584 585 586 587 588 589 ... 845 846

Comentarios a estos manuales

Sin comentarios

Brocade Multi-Service IronWare Routing Configuration Guide Manual de usuario Pagina 584

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Multi-Service IronWare Routing Configuration Guide