Brocade Multi-Service IronWare Routing Configuration Guide Manual de usuario descargar pdf (Pagina 739)

100

101

Multi-Service IronWare Routing Configuration Guide 711

53-1003033-02

IS-IS CLI levels

FIGURE 36 IPv6 IS-IS CLI levels

The IPv6 IS-IS CLI levels are as follows:

• A global level for the configuration of the IS-IS protocol. At this level, all IS-IS configurations at

this level apply to IPv4 and IPv6. You enter this layer using the router isis command.

• Under the global level, you specify an address family. Address families separate the IS-IS

configuration IPv6 and IPv4. You enter configurations that are for a specific You enter this

level by entering the address-family command at the router IS-IS level.

• Under the address family level, you select a sub-address family, which is the type of routes

for the configuration. For IS-IS, you specify unicast.

• An interface level

Global configuration level

You enter the global configuration level of IS-IS by entering the following command:

Brocade(config)#router isis

Brocade(config-isis-router)#

Syntax: router isis

The (config-isis-router)# prompt indicates that you are at the global level for IS-IS. Configurations

you enter at this level apply to both IS-IS IPv4 and IS-IS IPv6.

Address family configuration level

The implementation of IPv6 IS-IS includes a new configuration level: address family. You enter IS-IS

definitions for IPv6 IS-IS under this level. Address-family allows you to create configurations for IPv6

IS-IS unicast routes that are separate and distinct from configurations for IPv4 IS-IS unicast routes.

Under the address family level, Brocade devices support the unicast address family configuration

level only. The device enters the IPv6 IS-IS unicast address family configuration level when you

enter the following command while at the global IS-IS configuration level:

Brocade(config-isis-router)# address-family ipv6 unicast

Brocade(config-isis-router-ipv6u)#

Syntax: address-family ipv6 unicast

The (config-isis-router-ipv6u)# prompt indicates that you are at the IPv6 IS-IS unicast address

family configuration level. While at this level, you can access several commands that allow you to

configure IPv6 IS-IS unicast routes.

1 2 ... 734 735 736 737 738 739 740 741 742 743 744 ... 845 846

Comentarios a estos manuales

Sin comentarios

Brocade Multi-Service IronWare Routing Configuration Guide Manual de usuario Pagina 739

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Multi-Service IronWare Routing Configuration Guide