Brocade Multi-Service IronWare Routing Configuration Guide Manual de usuario descargar pdf (Pagina 317)

100

101

Multi-Service IronWare Routing Configuration Guide 289

53-1003033-02

Displaying IPv4 IS-IS information

The Brocade device applies the interface-level metric to routes originated on the interface and also

when calculating routes. The Brocade device does not apply the metric to link-state information

that the Brocade device receives from one IS and floods to other ISs.

The default interface metric is 10. You can change the metric on an individual interface to a value

in one of the following ranges:

• 1 – 63 for the narrow metric style (the default metric style for IPv4 ISIS)

• 1 – 16777215 for the wide metric style (the default metric style for IPv4 ISIS)

NOTE

If the metric value you want to use is higher than 63 but you have not changed the metric style to

wide, change the metric style first, then set the metric. The IS-IS neighbors that will receive the

advertisements also must be enabled to receive wide metrics.

To change the IS-IS metric on an interface, use the following CLI method.

Brocade(config)# interface ethernet 2/8

Brocade(config-if-e1000-2/8)# isis metric 15

Syntax: [no] isis metric num [level-1 | level-2]

The num parameter specifies the metric. The range of values you can specify depends on the

metric style. You can specify 1 – 63 for the narrow metric style or 1 – 16777215 for the wide metric

style. The default in either case is 10.

The level-1 | level-2 parameter applies the change to only the level you specify. If you do not use

this parameter, the change applies to both levels.

Displaying IPv4 IS-IS information

You can display the following information:

• General IS-IS Information – “Displaying ISIS general information” on page 289

• The active configuration (the IS-IS commands in the running-config) – refer to “Displaying the

IS-IS configuration in the running-config” on page 293

• Name mappings – “Displaying the name mappings” on page 294

• Neighbor information – “Displaying neighbor information” on page 294

• Neighbor adjacency changes – “Displaying IS-IS Syslog messages” on page 296

• Interface information – “Displaying interface information” on page 297

• Route information – “Displaying route information” on page 301

• LSP database entries – “Displaying LSP database entries” on page 302

• Traffic statistics – “Displaying traffic statistics” on page 306

• Error statistics – “Displaying error statistics” on page 307

• IS-IS Log – “Displaying the IS-IS SPF Log” on page 310

Displaying ISIS general information

To display general IPv4 IS-IS information, enter the following command at any CLI level.

1 2 ... 312 313 314 315 316 317 318 319 320 321 322 ... 845 846

Comentarios a estos manuales

Sin comentarios

Brocade Multi-Service IronWare Routing Configuration Guide Manual de usuario Pagina 317

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Multi-Service IronWare Routing Configuration Guide