Brocade Multi-Service IronWare Routing Configuration Guide Manual de usuario descargar pdf (Pagina 657)

100

101

Multi-Service IronWare Routing Configuration Guide 629

53-1003033-02

show ipv6 /jointfilesconvert/1441120/bgp vrf summary

Examples The following example displays BGP4+ summary information:

Brocade#show ipv6 /jointfilesconvert/1441120/bgp vrf abc summary

BGP4 Summary

Router ID: 1.1.1.1 Local AS Number: 100

Confederation Identifier: not configured

Confederation Peers:

Maximum Number of IP ECMP Paths Supported for Load Sharing: 1

Number of Neighbors Configured: 1, UP: 1

Number of Routes Installed: 3, Uses 258 bytes

Number of Routes Advertising to All Neighbors: 0 (0 entries)

Number of Attribute Entries Installed: 1, Uses 90 bytes

Neighbor Address AS# State Time Rt:Accepted Filtered Sent

ToSend

3:3:3::3 100 ESTAB 0h15m23s 3 0 0

History

State The state of the session with the neighbor. The states are from the perspective of this

device of the session, not the perspective of the neighbor. The state values are based

on the BGP4 state machine values described in RFC 1771 and can be one of the

following for each device:

• IDLE – The BGP4 process is waiting to be started. Usually, enabling BGP4 or

establishing a neighbor session starts the BGP4 process.

• A minus sign (-) indicates that the session has gone down and the software is

clearing or removing routes.

• ADMND – The neighbor has been administratively shut down.

• A minus sign (-) indicates that the session has gone down and the software is

clearing or removing routes.

• CONNECT – BGP4 is waiting for the connection process for the TCP neighbor

session to be completed.

• ACTIVE – BGP4 is waiting for a TCP connection from the neighbor.

NOTE: When the state frequently changes between CONNECT and ACTIVE, there may

be a problem with the TCP connection.

• OPEN SENT – BGP4 is waiting for an Open message from the neighbor.

• OPEN CONFIRM – BGP4 has received an OPEN message from the neighbor and

is now waiting for either a KEEPALIVE or NOTIFICATION message. When the

device receives a KEEPALIVE message from the neighbor, the state changes to

Established. When the message is a NOTIFICATION, the state changes to Idle.

• ESTABLISHED – BGP4 is ready to exchange UPDATE messages with the neighbor.

• When there is more BGP data in the TCP receiver queue, a plus sign (+) is also

displayed.

Time The time that has passed since the state last changed.

Accepted The number of routes received from the neighbor that this device installed in the

BGP4 route table. Usually, this number is lower than the RoutesRcvd number. The

difference indicates that this device filtered out some of the routes received in the

UPDATE messages.

Filtered The routes or prefixes that have been filtered out.

Sent The number of BGP4 routes the device has sent to the neighbor.

ToSend The number of routes the device has queued to advertise and withdraw to a neighbor.

Output field Description

Release Command History

Multi-Service IronWare R05.5.00 This command was introduced.

1 2 ... 652 653 654 655 656 657 658 659 660 661 662 ... 845 846

Comentarios a estos manuales

Sin comentarios

Brocade Multi-Service IronWare Routing Configuration Guide Manual de usuario Pagina 657

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Multi-Service IronWare Routing Configuration Guide