Brocade Multi-Service IronWare Routing Configuration Guide Manual de usuario descargar pdf (Pagina 302)

100

101

274 Multi-Service IronWare Routing Configuration Guide

53-1003033-02

Configuring IPv4 address family route parameters

Syntax: [no] redistribute ospf [level-1 | level-1-2 | level-2 ] |

match [external1 | external2 | internal] |

metric number |

metric-type [external | internal] |

route-map name

Most of the parameters are the same as the parameters for the redistribute static command.

However, the redistribute ospf command also has the match external1 | external2 | internal

parameter. This parameter specifies the OSPF route type you want to redistribute into IPv4 IS-IS. By

default, the redistribute ospf command redistributes only internal routes.

• external1 – An OSPF type 1 external route.

• external2 – An OSPF type 2 external route.

• internal – An internal route calculated by OSPF.

Redistributing BGP4+ routes into IPv4 IS-IS

To redistribute BGP4+ routes into IPv4 IS-IS, enter the following command at the IPv4 IS-IS unicast

address family configuration level.

Brocade(config-isis-router-ipv4u)# redistribute /jointfilesconvert/1441120/bgp

This command configures the device to redistribute all its BGP4 routes into Level-2 IPv4 IS-IS.

Syntax: [no] redistribute /jointfilesconvert/1441120/bgp [level-1 | level-1-2 | level-2] |

metric number | metric-type [external | internal] |

route-map name

The parameters are the same as the parameters for the redistribute static command.

Redistributing IPv4 IS-IS routes within IPv4 IS-IS

In addition to redistributing routes from other route sources into IPv4 IS-IS, the Brocade device can

redistribute Level 1 IPv4 IS-IS routes into Level 2 IPv4 IS-IS routes, and Level 2 IPv4 IS-IS routes into

Level 1 IPv4 IS-IS routes. By default, the device redistributes routes from Level 1 into Level 2.

NOTE

The Brocade device automatically redistributes Level 1 routes into Level 2 routes, even if you do not

enable redistribution.

For example, to redistribute all IPv4 IS-IS routes from Level 2 into Level 1, enter the following

command at the IPv4 IS-IS unicast address family configuration level.

Brocade(config-isis-router-ipv4u)# redistribute isis level-2 into level-1

The device automatically redistributes Level-1 routes into Level 2.

Syntax: [no] redistribute isis level-1 into level-2 | level-2 into level-1 [prefix-list name]

The level-1 into level-2 | level-2 into level-1 parameter specifies the direction of the redistribution:

• level-1 into level-2 – Redistributes Level 1 routes into Level 2. This is the default.

• level-2 into level-1 – Redistributes Level 2 routes into Level 1.

The prefix-list name specifies an IP prefix list.

1 2 ... 297 298 299 300 301 302 303 304 305 306 307 ... 845 846

Comentarios a estos manuales

Sin comentarios

Brocade Multi-Service IronWare Routing Configuration Guide Manual de usuario Pagina 302

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Multi-Service IronWare Routing Configuration Guide