Brocade FastIron Ethernet Switch Security Configuration Gu Manual de usuario Pagina 130

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 396
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 129
device(config-vlan-101)#router-interface ve 101
device(config-vlan-101)#exit
device(config)#enable ACL-per-port-per-vlan
device(config)#ip access-list extended 101
device(config-ext-nacl)#bridged-routed
device(config)#write memory
device(config)#exit
device#reload
...
device(config-vif-101)#ip access group 1 in ethernet 1 ethernet 3 ethernet 4
NOTE
The enable ACL-per-port-per-vlan command must be followed by the write-memory and reload
commands to place the change into effect.
Enabling ACL filtering based on VLAN membership or VE port
membership
NOTE
This section applies to IPv4 ACLs only. IPv6 ACLs do not support ACL filtering based on VLAN
membership or VE port membership. This feature is not applicable to outbound traffic.
You can apply an inbound IPv4 ACL to specific VLAN members on a port (Layer 2 devices only) or to
specific ports on a virtual interface (VE) (Layer 3 Devices only). By default, this feature support is
disabled. To enable it, enter the following commands at the Global CONFIG level of the CLI.
device(config)#enable ACL-per-port-per-vlan
device(config)#write memory
device(config)#exit
device#reload
NOTE
For complete configuration examples, see Applying an IPv4 ACL to specific VLAN members on a port
(Layer 2 devices only) on page 131 and Applying an IPv4 ACL to a subset of ports on a virtual
interface (Layer 3 devices only) on page 132.
NOTE
For FastIron X Series devices, you must save the configuration and reload the software to place the
change into effect.
Syntax: [no] enable ACL-per-port-per-vlan VLAN-ID
Enter the no form of the command to disable this feature.
Configuration notes for ACL filtering
Before enabling this feature on FastIron SX series devices that have second-generation modules,
make sure that the VLAN numbers are contiguous. For example, the VLAN numbers can be 201,
Enabling ACL filtering based on VLAN membership or VE port membership
130 FastIron Ethernet Switch Security Configuration Guide
53-1003088-03
Vista de pagina 129
1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 395 396

Comentarios a estos manuales

Sin comentarios