
NOTE
Web management is not supported in Release 8.0.00a and later releases. If web management is
enabled, you must configure the no web-management command to disable it.
NOTE
For all Brocade devices, RADIUS Challenge is supported for 802.1x authentication but not for login
authentication. Also, multiple challenges are supported for TACACS+ login authentication.
Securing access methods
The following table lists the management access methods available on a Brocade device, how they
are secured by default, and the ways in which they can be secured.
Ways to secure management access to Brocade devices TABLE 2
Access method How the access method is
secured by default
Ways to secure the
access method
See page
Serial access to the
CLI
Not secured Establish passwords
for management
privilege levels
Setting passwords for
management privilege
levels on page 32
Access to the
Privileged EXEC and
CONFIG levels of the
CLI
Not secured Establish a password
for Telnet access to
the CLI
Setting a Telnet
password on page 32
Establish passwords
for management
privilege levels
Setting passwords for
management privilege
levels on page 32
Set up local user
accounts
Local user accounts on
page 35
Configure TACACS/
TACACS+ security
TACACS and TACACS+
security on page 42
Configure RADIUS
security
RADIUS security on page
58
Telnet access Not secured Regulate Telnet
access using ACLs
Using an ACL to restrict
Telnet access on page
23
Allow Telnet access
only from specific IP
addresses
Restricting Telnet access to a
specific IP address on page 26
Restrict Telnet access
based on a client MAC
address
Restricting access to the device
based on IP orMAC address on
page 26
Securing access methods
20 FastIron Ethernet Switch Security Configuration Guide
53-1003088-03
Comentarios a estos manuales