Brocade Multi-Service IronWare Switching Configuration Gui Manual de usuario descargar pdf (Pagina 157)

100

101

Multi-Service IronWare Switching Configuration Guide 127

53-1003036-02

Deploying a LAG

Brocade(config)# lag blue static

Brocade(config-lag-blue)# deploy

Brocade(config-lag-blue)# disable ethernet 3/1

Syntax: [no] disable ethernet [slot/port] | named [name]

Use the ethernet option with the appropriate [slot/port] variable to specify a Ethernet port within

the LAG that you want to disable.

Use the named option with the appropriate [slot/port] variable to specify a named port within the

LAG that you want to disable.

Enabling ports within a LAG

You can enable an individual port within a LAG using the enable command within the LAG

configuration as shown in the following.

Brocade(config)# lag blue static

Brocade(config-lag-blue)# deploy

Brocade(config-lag-blue)# enable ethernet 3/1

Syntax: [no] enable ethernet [slot/port] | named [name]

Use the ethernet option with the appropriate [slot/port] variable to specify a Ethernet port within

the LAG that you want to enable.

Use the named option with the appropriate [slot/port] variable to specify a named port within the

LAG that you want to enable.

Adding a Port to Currently Deployed LAG

Ports can be added to a currently deployed LAG. Adding a port to a deployed LAG uses the same

procedures as described in “Adding Ports to a LAG or Deleting Ports from a LAG”. When you add

ports to a deployed LAG, the MAC address of the port being added is changed to that of the primary

port of the LAG to which it is being added.

When adding a port to a currently deployed static LAG the LACP BPDU Forwarding configuration

must be the same as the LAG. Follow the procedure on “Enabling and Disabling LACP BPDU

Forwarding on a Port”.

Deleting a Port from a Currently Deployed LAG

Ports can be deleted from a currently deployed LAG. Deleting a port in a currently deployed LAG

uses the same procedures as described in “Adding Ports to a LAG or Deleting Ports from a LAG”.

However, when deleting ports from a currently deployed LAG you must consider the following:

• The primary port cannot be removed.

• If removal of a port will result in the trunk threshold value becoming greater than the number

of ports in the LAG, the port deletion will be rejected.

• The port being deleted must be in the “disabled” state or you must use the forced option (as

described in the following command syntax) when deleting it from a currently deployed LAG.

Otherwise, the deletion request will be denied and the following error message will be

displayed: “Error: ports to be deleted from the deployed LAG are not disabled, deleting these

ports from the LAG may form a loop – aborted.”

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 983 984

Comentarios a estos manuales

Sin comentarios

Brocade Multi-Service IronWare Switching Configuration Gui Manual de usuario Pagina 157

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Multi-Service IronWare Switching Configuration Gui