Brocade Multi-Service IronWare Switching Configuration Gui Manual de usuario descargar pdf (Pagina 817)

100

101

Multi-Service IronWare Switching Configuration Guide 787

53-1003036-02

Configuring static routes

The metric parameter specifies the cost of the route and can be a number from 1 – 16. The default

is 1.

NOTE

If you specify 16, RIP considers the metric to be infinite and thus also considers the route to be

unreachable.

The tag num parameter specifies the tag value of the route. Possible values: 0 - 4294967295.

Default: 0.

The distance num parameter specifies the administrative distance of the route. When comparing

otherwise equal routes to a destination, the Brocade device prefers lower administrative distances

over higher ones, so make sure you use a low value for your default route. Possible values: 1 - 255.

Default: 1.

NOTE

The Brocade device will replace the static route if it receives a route with a lower administrative

distance.

The name string parameter specifies the name assigned to a route. The static route name is

descriptive and an optional feature. It does not affect the selection of static routes.

NOTE

Using the no ip route command will only remove the name if configured. Run the no command again

without the name parameter to remove the actual Static Route.

Configuring a static IP route between VRFs

You can configure a static route next hop to be in a different VRF. This can be done for the following:

• From the default VRF to a non-default VRF

• From a non-default VRF to a non-default VRF

• From a non-default VRF to the default VRF

• From one VRF to an IP interface in a different VRF.

NOTE

RPF is not supported with the Static Route between VRFs feature.

NOTE

For information on disabling gratuitous ARP requests on a VRF IP interface, refer to “Disabling

gratuitous ARP requests for local proxy ARP” on page 752.

Configuring a static route from the default VRF to a non-default VRF

To configure an IP static route with a destination address of 10.0.0.0/24 and a next-hop router with

an IP address of 10.1.1.1 in the non-default VRF named “blue”, enter the following at the general

configuration prompt.

Brocade(config)# vrf red

Brocade(config-vrf-red)# ip route 10.128.2.69/24 next-hop-vrf blue 10.1.1.1

1 2 ... 812 813 814 815 816 817 818 819 820 821 822 ... 983 984

Comentarios a estos manuales

Sin comentarios

Brocade Multi-Service IronWare Switching Configuration Gui Manual de usuario Pagina 817

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Multi-Service IronWare Switching Configuration Gui