Brocade Mobility Access Point System Reference Guide (Supp Manual de usuario Pagina 125

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 854
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 124
Brocade Mobility Access Point System Reference Guide 115
53-1003100-01
5
FIGURE 32 Network - L2TPv3 screen - General tab
5. Set the following General Settings for an L2TPv3 profile configuration:
6. Select the L2TPv3 Tunnel tab.
Host Name
Define a 64 character maximum hostname to specify the name of the host that’s sent tunnel
messages. Tunnel establishment involves exchanging 3 message types (SCCRQ, SCCRP and SCCN)
with the peer. Tunnel IDs and capabilities are exchanged during the tunnel establishment with the
host.
Router ID
Set either the numeric IP address or the integer used as an identifier for tunnel AVP messages. AVP
messages assist in the identification of a tunnelled peer.
UDP Listen Port
Select this option to set the port used for listening to incoming traffic. Select a port from 1,024 -
65,353.
Tunnel Bridging
Select this option to enable or disable bridge packets between two tunnel end points. This setting is
disabled by default.
Vista de pagina 124
1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 853 854

Comentarios a estos manuales

Sin comentarios