Brocade Mobility Access Point System Reference Guide (Supp Manual de usuario descargar pdf (Pagina 641)

100

101

Brocade Mobility Access Point System Reference Guide 631

53-1003100-01

NOTE

Leave the Source, Device and Mobile Unit fields at the default setting of 00:00:00:00:00:00 to allow

all MAC addresses.

3. Select the Add to Active Filters button to create a new filter and add it to the Active Event Filters

table. When added, the filter uses the configuration defined in the Customize Event Filters

field.

4. Refer to the Active Event Filters table to set the following parameters:

To activate all the events in the Active Events Filters table, select the Enable All Events button. To

stop event generation, select Disable All Events.

To enable an event in the Active Event Filters table, select the event, then select the Activate

Defined Filter button.

NOTE

Filters cannot be persisted across sessions. They must be created every time a new session is

established.

Select View Events from the upper, left-hand, side of the Fault Management browser.

FIGURE 2 Fault Management - View Events screen

Use the View Events screen to track and troubleshoot events using source and severity levels

defined in the configure events screen.

1 2 ... 636 637 638 639 640 641 642 643 644 645 646 ... 853 854

Comentarios a estos manuales

Sin comentarios

Brocade Mobility Access Point System Reference Guide (Supp Manual de usuario Pagina 641

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Mobility Access Point System Reference Guide (Supp