Brocade Mobility Access Point System Reference Guide (Supp Manual de usuario Pagina 28

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 854
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 27
18 Brocade Mobility Access Point System Reference Guide
53-1003100-01
3
NOTE
Note the difference in the number of steps between the Typical Setup and Advanced Setup Wizards.
9. Select Save/Commit within each page to save the updates made to that page's configuration.
Select Next to proceed to the next page listed in the Navigation Panel. Select Back to revert to
the previous screen without saving your updates.
NOTE
While you can navigate to any page in the navigation panel, you cannot complete the Initial Setup
Wizard until each task in the Navigation Panel has a green check mark.
The following sections describe the two different wizards and their parameters. The available
wizards are:
Typical Setup Wizard
Advanced Setup Wizard
Typical Setup Wizard
Using the Initial Setup Wizard
The Typical Setup is the recommended wizard. This wizard uses default parameters for most of the
configuration parameters and creates a working network with the fewest steps.
The Typical Setup wizard consists of the following:
Network Topology Selection
LAN Configuration
WAN Configuration
Wireless LAN Setup
Summary And Commit Screen
To configure the access point using the Typical Setup Wizard:
1. Select Typical Setup from the Choose One type to Setup the Access Point field.
2. Select Next.
The Initial Setup Wizard displays the Access Point Settings screen to define the access point's
Standalone versus Virtual Controller AP functionality. This screen also enables selection of the
country of operation for the access point.
Vista de pagina 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 853 854

Comentarios a estos manuales

Sin comentarios