Brocade Mobility Access Point System Reference Guide (Supp Manual de usuario descargar pdf (Pagina 256)

100

101

246 Brocade Mobility Access Point System Reference Guide

53-1003100-01

Select + Add Row below the Network Time Protocol (NTP) table to define (or override) the

configurations of NTP server resources used it obtain system time. Set the following parameters to

define the NTP configuration:

Refer to the RF Domain Manager field to configure this device as a RF Domain manager.

Select the Capable option to enable or disable this device as a RF Domain manager.

Select the Priority option to enable configuring a priority value for this device when election to

become a Domain Manager is conducted. Set a value using the spinner control. Setting a low value

increases the chance of this device becoming the RF Domain manager.

Select OK to save the changes and overrides made to the general profile configuration. Select

Reset to revert to the last saved configuration.

Refer to the following to complete the override of the access point’s entire profile configuration:

• Radio Power Overrides

• Adoption Overrides

• Profile Interface Override Configuration

• Overriding the Network Configuration

• WAN Backhaul Overrides

• Overriding a Security Configuration

• Overriding a Services Configuration

• Overriding a Management Configuration

• Overriding an Advanced Configuration

• Overriding Mesh Point Configuration

• Overriding Environmental Sensor Configuration

Radio Power Overrides

Device Overrides

Use the Power screen to set or override one of two power modes (3af or Auto) for an access point.

When Automatic is selected, the access point safely operates within available power. Once the

power configuration is determined, the access point configures its operating power characteristics

based on its model and power configuration.

AutoKey

Select this option to enable an autokey configuration for the NTP resource. This is a key randomly

generated for use between the access point and its NTP resource. The default setting is disabled.

Key

If an autokey is not being utilized, you must manually enter a 64 character maximum key shared for

interoperation.

Prefer

Select this option to designate this particular NTP resource as preferred. If designating multiple

NTP resources, preferred resources will be given first opportunity to connect to and provide NTP

calibration.

Server IP

Set the IP address of each server added as a potential NTP resource.

Version

Use the spinner control to specify the version number used by this NTP server resource. The default

setting is 0.

1 2 ... 251 252 253 254 255 256 257 258 259 260 261 ... 853 854

Comentarios a estos manuales

Sin comentarios

Brocade Mobility Access Point System Reference Guide (Supp Manual de usuario Pagina 256

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Mobility Access Point System Reference Guide (Supp