Brocade Mobility Access Point System Reference Guide (Supp Manual de usuario Pagina 258

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 854
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 257
248 Brocade Mobility Access Point System Reference Guide
53-1003100-01
5
FIGURE 125 Device Overrides - Power screen
Use the Power Mode drop-down menu to set or override the Power Mode Configuration on this AP.
NOTE
Single radio model access point’s always operate using a full power configuration. The power
management configurations described in this section do not apply to single radio models.
When an access point is powered on for the first time, the system determines the power budget
available. Using the Automatic setting, the access point automatically determines the best power
configuration based on the available power budget. Automatic is the default setting.
If 802.3af is selected, the access point assumes 12.95 watts are available. If the mode is changed,
the access point requires a reset to implement the change. If 802.3at is selected, the access point
assumes 23 - 26 watts are available.
Set or override the access point radio’s 802.3af Power Mode and the radio’s 802.3at Power Mode.
Use the drop-down menu to define a mode of either Range or Throughput.
Select Throughput to transmit packets at the radio’s highest defined basic rate (based on the
radio’s current basic rate settings). This option is optimal in environments where the transmission
range is secondary to broadcast/multicast transmission performance. Select Range when range is
preferred over performance for broadcast/multicast (group) traffic. The data rates used for range
are the lowest defined basic rates. Throughput is the default setting for both 802.3af and 802.3at.
Select OK to save the changes and overrides made to the access point power configuration. Select
Reset to revert to the last saved configuration
Vista de pagina 257
1 2 ... 253 254 255 256 257 258 259 260 261 262 263 ... 853 854

Comentarios a estos manuales

Sin comentarios