Brocade Mobility RFS7000-GR Controller CLI Reference Guide Manual de usuario Pagina 328

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 607
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 327
314 Brocade Mobility RFS7000-GR Controller CLI Reference Guide
53-1001945-01
Interface Config commands
12
duplex
Interface Config commands
Use this command to specify the duplex mode of operation.
NOTE
- Duplexity can only be set for an Ethernet type interface. Enter the (config-if) instance using an
ge/me parameter in an interface mode.
- Duplex cannot be set until the speed is set to a non-auto value.
Syntax
duplex(auto|full|half)
Parameters
Usage Guidelines
Duplex defines the type of communication used by the port. The switch, by default, is set as
auto
duplex. In auto mode the duplex is selected based on the connected network hardware.
Example
RFS7000(config)#interface ge4
RFS7000(config-if)#duplex ?
auto set auto-negotiate
full set full-duplex
half set half-duplex
RFS7000(config-if)#duplex full
RFS7000(config-if)#
auto Sets the auto-negotiate parameter. Port is in full-duplex mode.
full Sets full-duplex where data can be passed in both direction simultaneoulsy.
half Sets half-duplex where data can only be passed in one direction at a time.
Vista de pagina 327
1 2 ... 323 324 325 326 327 328 329 330 331 332 333 ... 606 607

Comentarios a estos manuales

Sin comentarios