
416 Brocade Mobility RFS7000-GR CLI Reference Guide
53-1001945-01
DHCP Config Commands
17
dns-server
DHCP Config Commands
Use this command to configure the DNS server’s IP address available to the DHCP clients
connected to the pool. Use the
no dns-server command to remove DNS server list.
Syntax
dns-server <ip address1A.B.C.D> <ip address2A.B.C.D> <ip address3A.B.C.D>
.....<ip address8A.B.C.D>
Parameters
Usage Guidelines
For DHCP client’s, the DNS server’s IP address is used to map the host name to IP address. The
DHCP client uses the DNS servers IP address based on the order (sequence) configured.
Example
RFS7000(config-dhcp)#dns-server 2.2.2.222
RFS7000(config-dhcp)#
dns-server <IP
addressA.B.C.D>
Configures the DNS Server’s IP address.
• <IP address>A.B.C.D> – Server's IP address.
Comentarios a estos manuales