Brocade Mobility RFS7000-GR Controller CLI Reference Guide Manual de usuario Pagina 497

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 607
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 496
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 483
53-1001945-01
Chapter
20Wireless Instance
In this chapter
Wireless Configuration Commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 483
Use the
(config-wireless) instance to configure wireless parameters.
Wireless Configuration Commands
The following table summarizes the Global Config commands.
TABLE 17 Wireless configuration commands
Command Description Ref.
aap Invokes AAP related commands. page 485
admission-control Use this command to disable admission control across all radios. page 486
adopt-unconf-radio Adopts a radio even if not configured. The default templates are used for
configuration.
page 487
adoption-pref-id Defines a preference identifier for the switch. All radios configured with this
identifier are more likely to be adopted by this switch.
page 488
ap IEnvokesinvokes AP related commands to define the name and location of
the AP.
page 489
ap-containment Invokes Rogue AP Containment commands. page 490
ap-detection Access port detection configuration commands. page 491
ap-ip Modifies static IP information for access ports. page 492
ap-standby-attempt
s-threshold
Reverts the number of attempts after which the standby switch adopts its
default value 11.
page 495
ap-timeout Changes the default inactivity timeout for access-port. page 494
auto-select-channel
s
Specifies a list from which channels can be picked. page 495
broadcast-tx-speed Sets the rate at which broadcast and multicast traffic is transmitted. page 497
clrscr Clears the display screen. page 498
cluster-master-supp
ort
Change settings for cluster master support, required for cluster-level
functioning.
page 499
country-code Configures the country of operation. Regulatory configuration (channels,
self healing offset) of all configured radios is reset to default values.
page 500
debug Initiates debugging functions. page 501
dhcp-one-portal-fpr
ward
Forwards broadcast DHCP responses to one portal when the destination
mobile-unit is known from the response contient.
page 503
Vista de pagina 496
1 2 ... 492 493 494 495 496 497 498 499 500 501 502 ... 606 607

Comentarios a estos manuales

Sin comentarios