Brocade Mobility RFS7000-GR Controller CLI Reference Guide Manual de usuario Pagina 535

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 607
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 534
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 521
53-1001945-01
Wireless Configuration Commands
20
no
Wireless Configuration Commands
Use this command to negate a command or set its defaults.
Syntax
no[aap|admission-control|adopt-unconf-radio|adoption-pref-id|ap|ap-containment|ap
-detection|ap-ip|ap-standby-attempts-threshold ap-timeout|auto-select-channels
ap-udp-port|broadcast-tx-speed|cluster-master-support|country-code|debug|dhcp-one
-portal-forward |dhcp-sniff-state|
fix-windows-dhcp fix-broadcast-dhcp-rsp
|hotspot|load-balance|mac-auth-local|manual-wlan-mapping|mobile-unit|
mobility|multicast-packet-limit|multicast-throttle-watermarks|nas-id|nas-port-id|
non-preferred-ap-attempts-threshold|proxy-arp|
qos-mapping|radio|self-heal|sensor|service|smart-scan-channels|wips|wlan|wlan-bw-
allocation]
Parameters
The
no command negates any command associated with it. Wherever required, use the same
parameters associated with the command getting negated.
Example
RFS7000(config-wireless)#no mobility enable
RFS7000(config-wireless)#
Vista de pagina 534
1 2 ... 530 531 532 533 534 535 536 537 538 539 540 ... 606 607

Comentarios a estos manuales

Sin comentarios