Brocade Mobility RFS7000-GR Controller CLI Reference Guide Manual de usuario descargar pdf (Pagina 539)

100

101

Brocade Mobility RFS7000-GR Controller CLI Reference Guide 525

53-1001945-01

Wireless Configuration Commands

Parameters

<1-4096>

A single radio index.

admission-control (voice)

Admission control parameters.

• voice – voice parameters.

• max-mus <0-256> – Maximum mobile units to be admitted.The

maximum value range is <0-256>.

• max-perc <0-100>– Maximum percentage of air time allocated to voice

traffic.The maximum percentage is 100.

• max-roamed-mus <0-256> – The maximum roamed mobile units to be

admitted.

• res-roam-perc – The percentage of air time allocated exclusively for

roamed mobile-unit.This value <0-100> is calculated relative to the

configured max air time percentage allocated for voice.

adoption-policy [allow|deny]

Specifies adoption policy.

• allow – Allows adoption

• deny – Denies adoption.

adoption-pref-id

<0-65535>

A preference identifier for this radio. The radio is more likely to be adopted by a

preferred switch.

NOTE: A Brocade Mobility 7131N-FGR has two radio’s. Configuring any one radio

as a pref-id ensures the other radio is also configured with this pref-id.

A Brocade Mobility 7131N-FGR cannot be adopted by two switches

simultaneously.

ampdu

MAC protocol frames.

• min-spacing – Specifies the spacing between received MPDUs. The values

are as follows:

• .25 microsec

• .5 microsec

• 0 microsec

• 1 microsec

• 2 microsec

• 4 microsec

• 8 microsec

• rx-limit –Specifies Receive buffer limit. The values are as follows:

• 16382 bytes

• 32767 bytes

• 65535 bytes

• 8191 bytes

• tx-enable [min-spacing|rx-limit|tx-limit] – Enables Transmit A-MPDU.

• tx-limit <0-65535> – Transmit Buffer Limit of value <0-65535>.

antenna-mode

<diversity|mimo|primary|seco

ndary>

Antenna diversity mode. Select from the following options:

• diversity–Full diversity (both antennas).

• mimo – MIMO

• primary–Primary antenna only.

• secondary–Secondary antenna only.

base-bridge

[enable|max-clients]

Base bridge settings.

• enable – Enables base bridge.

• max-clients <0-12> – Maximum client bridges allowed.

beacon-interval

<50-200>

Beacon interval in K-uSec.

bridge-fwd-delay<4-30>

STP Bridge Forward Delay time in seconds.

1 2 ... 534 535 536 537 538 539 540 541 542 543 544 ... 606 607

Comentarios a estos manuales

Sin comentarios

Brocade Mobility RFS7000-GR Controller CLI Reference Guide Manual de usuario Pagina 539

Comentarios a estos manuales

Relacionado con productos y manuales para Accesorios De Computador Brocade Mobility RFS7000-GR Controller CLI Reference Guide