
Brocade Mobility RFS7000-GR Controller CLI Reference Guide 523
53-1001945-01
Wireless Configuration Commands
20
qos-mapping
Wireless Configuration Commands
Use this command to configure QoS mappings between wired and wireless domains.
Syntax
qos-mapping(wired-to-wireless|wireless-to-wired)
qos-mapping wired-to-wireless(dot1p
<0-7>
|dscp
<0-63>
)
(background|best-effort|video|voice)
qos-mapping wireless-to-wired(background|best-effort|video|voice)
dot1p
<0-7>
Parameters
Example
RFS7000(config-wireless)#qos-mapping wireless-to-wired backgroundtid0 dot1p 5
RFS7000(config-wireless)#
wired-to-wireless
Mappings used while switching wired traffic over the air.
• dot1p<0-7> – Configures the mapping of 802.1p tags to access categories.
Specify more than one 802.1p tag (0-7) if needed.
• dscp<0-63> – Configures the mapping of DSCP values to access categories.
Specify more than one DSCP value (0-63) if needed.
• tid0 best effort category traffic
• tid1 background category traffic
• tid2 background category traffic
• tid3 best effort category traffic
• tid4 video traffic category traffic
• tid5 video traffic category traffic
• tid6 voice traffic category traffic
• tid7 voice traffic category traffic
wireless-to-wired
Mappings used while switching wireless traffic to rest of the network.
• dot1p<0-7> – Configures 802.1p tags that correspond to selected access
categories.tid0 best effort category traffic
• tid1 background category traffic
• tid2 background category traffic
• tid3 best effort category traffic
• tid4 video traffic category traffic
• tid5 video traffic category traffic
• tid6 voice traffic category traffic
• tid7 voice traffic category traffic
• dotp1<0-7> – Configures the 802.1p tags that corresponds to selected
wireless traffic ID.Specify more than one 802.1p tag (0-7) if needed.
Comentarios a estos manuales