Brocade Network OS Message Reference v4.1.1 Manual de usuario descargar pdf (Pagina 110)

94 Network OS Message Reference

53-1003227-01

AUTH-1039

Message Neighboring switch has conflicting authentication policy: Port <Port Number>

disabled.

Message Type LOG

Severity ERROR

Probable Cause Indicates that the neighboring switch has a conflicting authentication policy enabled. The E_Port has

been disabled because the neighboring switch has rejected the authentication negotiation and the local

switch has a strict switch authentication policy.

Recommended

Action

Correct the switch policy configuration on either of the switches using the fcsp auth command, and then

enable the port using the no shutdown command.

AUTH-1040

Message Reject authentication on port <Port Number>, because switch authentication policy

is set to OFF.

Message Type LOG

Severity INFO

Probable Cause Indicates that the local switch has rejected the authentication because the switch policy is turned off. If

the neighboring switch has a strict (ON) switch policy, the port will be disabled due to conflicting

configuration settings. Otherwise, the E_Port will form without authentication.

Recommended

Action

If the port is disabled, correct the switch policy configuration on either of the switches using the fcsp auth

command, and then enable the port on neighboring switch using the no shutdown command. If the

E_Port has formed, no action is required.

AUTH-1041

Message Port <port number> has been disabled, because an authentication-reject was

received with code '<Reason String>' and explanation '<Explanation String>'.

Message Type LOG

Severity ERROR

Probable Cause Indicates that the specified port has been disabled because it received an authentication-reject response

from the connected switch or device. The error may indicate that an invalid entity tried to connect to the

switch.

Recommended

Action

Check the connection port for a possible security attack.

Check the shared secrets using the show fcsp auth-secret dh-chap command and reinitialize

authentication using the shutdown and no shutdown commands or the chassis disable and chassis

disable commands.

If the message persists, execute the copy support command and contact your switch service provider.

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 477 478

Sin comentarios

Brocade Network OS Message Reference v4.1.1 Manual de usuario Pagina 110