Brocade Network OS Message Reference v4.1.1 Manual de usuario Pagina 174

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 478
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 173
158 Network OS Message Reference
53-1003227-01
EM-1029
8
EM-1029
Message <FRU Id>, a problem occurred accessing a device on the I2C bus (<error code>).
Operational status (<state of the FRU when the error occurred>) not changed,
access is being retried.
Message Type LOG
Severity WARNING
Probable Cause Indicates that the inter-integrated circuit (I2C) bus had problems and a timeout occurred.
Recommended
Action
This is often a transient error.
Watch for the EM-1048 message, which indicates that the problem has been resolved.
If the error persists, check for loose or dirty connections. Remove all dust and debris prior to reseating
the field-replaceable unit (FRU). Replace the FRU if it continues to fail.
EM-1031
Message <FRU Id> ejector not closed.
Message Type LOG
Severity ERROR
Probable Cause Indicates that the environmental monitor (EM) has found a switch interface module that is inserted, but
the optical ejector switch is not latched. The interface module in the specified slot is treated as not
inserted.
Recommended
Action
Close the ejector switch (completely screw in the optical (middle) thumbscrew on the switch fabric
module (SFM)) if the field-replaceable unit (FRU) is intended for use. Refer to the appropriate Hardware
Reference Manual for instructions on inserting the switch interface modules.
EM-1032
Message <FRU Id> is faulted due to a PCI scan failure.
Message Type LOG | FFDC
Severity ERROR
Probable Cause Indicates that the interface module in the specified slot has been marked as faulty because the
peripheral component interconnect (PCI) scan during interface module validation failed.
Recommended
Action
Power cycle or reseat the interface module.
Execute the diag systemverification command to verify that the switch does not have hardware
problems.
If the problem persists, replace the interface module.
Vista de pagina 173
1 2 ... 169 170 171 172 173 174 175 176 177 178 179 ... 477 478

Comentarios a estos manuales

Sin comentarios